The XMAX V3 Nano is a one-trick pony that you’ll quickly master with the help of this guide. Grab your vape and let’s get into it.
What's in the box
1 x XMAX V3 Nano Vaporizer
1 x XMAX V3 Nano Glass Mouthpiece
1 x USB-C Charge Cable
2 x O-Rings
4 x Alcohol Cotton Pads
3 x Cotton Swabs
2 x Mesh Screens
1 x Brush
1 x Cleaning Tool
1 x Quickstart Guide
Charge it
Fully charge your V3 Nano before you jump right in. Take the included USB-C cable and plug the USB-C end into the bottom of V3 Nano and the USB-A end into a charge port. The V3 Nano will light up red while it’s charging, and turn green when it’s full.
Triple-click to go
The V3 Nano keeps it simple with one-button controls. Just triple-click to power it on or off, and that’s it.
When you turn it on, the LED will flash to show its battery level:
Green: Fully charged
White: Around 50%
Red: Low battery
After that, the light turns red and heating begins. In about 30 seconds, it’ll vibrate and switch to green to let you know it’s ready to hit. The session runs for three minutes before it automatically shuts off.
The oven and the glass stem
The oven sits right at the top of the device, and it’s where the included glass stem goes as well. Just take the stem and insert it filter-side down until it fits snugly in place.
Cleanse with a burnoff
Take just three minutes and run a quick burnoff session to cleanse your V3 Nano of any leftover manufacturing residues. Triple-click to turn it on and let it run until it turns off.
Grind and pack
The XMAX V3 Nano’s hybrid heater works best with a medium grind and a looser pack. Break out your herbs and grinder and get a nice, fluffy consistency.
Loosely fill the oven until there's a slight mound on top. Then insert the glass mouthpiece to tamp it down and lock everything in place. Pull it back out and you’ll notice a large gap between the herbs and the top of the vape. Leave that gap. That space is where the mouthpiece sit.
Pop the mouthpiece back in and you’re ready to go.
Heat it up
When you’re ready, triple-click the V3 Nano and let it heat up. After 30 seconds, it’ll turn green and vibrate twice to let you know it’s ready.
Soft and steady pulls
The V3 Nano performs best with slow and steady pulls of a few seconds. Your first few hits will be light and wispy. Give it a little time to build. The vapor really kicks in after a few draws, so ease into it and enjoy the ride.
Pro tip: Want to boost that first hit? Let it heat up like normal. When it vibrates, turn it off, then right back on again. That second heat cycle will charge the oven for a punchier first draw.
Empty the oven when you’re finished
When you’re all finished, pull the glass mouthpiece out and empty out the oven while it’s still warm. Take a brush or paper towel and clean off the bottom of the mouthpiece as well. This will help keep your V3 Nano cleaner for longer.
