The Puffco Plus is the Peak’s ultraportable little brother. If you’re unfamiliar with wax pens or concentrates in general, then take a look at this Quickstart guide to get up to speed with your Puffco Plus.
Puffco Plus Vaporizer
C$119.95
Free Canadian Shipping
Easy Returns
Expert Advice
Puffco Plus Quickstart: Quick Summary
- Charge it
- Run a test session
- Load it with the dart
- Press and hold the button and start your hit.
- Release the button just before you finish your hit.
- Swab out the oven while it’s still warm.
What’s in the box
- Puffco Plus Wax Pen
- Cleaning Swabs
- USB Charger
- Instruction Manual
Top it off
First, we’ll charge the Puffco Plus before we begin our first session. Take your Plus and unscrew it right above the button to reveal the charge connection. Screw the bottom half of your Plus (the battery) onto the USB Charger. A full charge will take roughly 30 minutes, and should last around 50 hits. The indicator light will change from Red to Green when fully charged.
Test session
Let’s run a quick test session to make sure everything is in working order. Screw the Plus back together and rapidly click the button five times to turn it on. Double-click to engage the heater into session mode and let it run until it times out, 12 seconds later. While it heats up, blow into the heater to see if hot air bounces back at you. If you feel warm air, you’re good to go.
Get ready for takeoff!
The Puffco Plus comes with its own handy scoop and load system, called the Dart. Unscrew the mouthpiece at the seal closest to the top to reveal the loading chamber and the Dart. Press down on the silicone tip to further extend the ceramic scoop, and use it to scrape up a rice-grain-sized amount of your chosen concentrate. Carefully place the Dart into the oven and press the mouthpiece down until the threadings touch. Screw the mouthpiece into place to finish up.
Heat it up
Now the fun begins! For this first session, we’ll start on the lowest heat setting and kick it off with some low temp flavor. Click four times to cycle through each temperature setting and land on the Blue temp setting.
Press and hold the button in to activate the heater, and start your hit. Release the button when you’re done. This is best for quick, small hits. For bigger, longer hits, double-click the button to activate its 12 second session mode, and take your draw until the Plus times out.
Cleanup
You can read more about cleaning your Puffco Plus in our cleaning guide, but, let’s go over a quick and simple cleaning routine. Once your Plus has cooled a bit, but is still warm, grab a cotton swab and wipe the concentrates out of the heating chamber. Concentrates will build up real fast, so it’s a good idea to do this after each session to maintain a clean, healthy Puffco Plus.
